Wintv

Un article de Wiki de la communauté Mandriva.

[modifier] Module ivtv

Vérifier que ce module est correctement chargé.

Pour le moment, (sous root) la commande dmesg retourne:

ivtv:  ==================== START INIT IVTV ====================
ivtv:  version 0.7.0 (tagged release) loading
ivtv:  Linux version: 2.6.17-13mdv SMP mod_unload 686 gcc-4.1
ivtv:  In case of problems please include the debug info between
ivtv:  the START INIT IVTV and END INIT IVTV lines, along with
ivtv:  any module options, when mailing the ivtv-users mailinglist.
usb 6-1: new low speed USB device using uhci_hcd and address 3
usb 6-1: configuration #1 chosen from 1 choice
input: Microsoft Microsoft 3-Button Mouse with IntelliEye(TM) as /class/input/input1
input: USB HID v1.10 Mouse [Microsoft Microsoft 3-Button Mouse with IntelliEye(TM)] on usb-0000:00:1d.2-1
usbcore: registered new driver usbmouse
drivers/usb/input/usbmouse.c: v1.6:USB HID Boot Protocol mouse driver
ivtv0: Autodetected Hauppauge WinTV PVR-150 card (cx23416 based)
ACPI: PCI Interrupt 0000:05:01.0[A] -> GSI 17 (level, low) -> IRQ 17
tveeprom 0-0050: The eeprom says no radio is present, but the tuner type
tveeprom 0-0050: indicates otherwise. I will assume that radio is present.
tveeprom 0-0050: Hauppauge model 26159, rev G1A5, serial# 10387336
tveeprom 0-0050: tuner model is TCL MPE05-2 (idx 105, type 38)
tveeprom 0-0050: TV standards PAL(B/G) PAL(I) SECAM(L/L') PAL(D/D1/K) (eeprom 0x74)
tveeprom 0-0050: audio processor is CX25843 (idx 37)
tveeprom 0-0050: decoder processor is CX25843 (idx 30)
tveeprom 0-0050: has radio, has IR remote
tuner 0-0061: chip found @ 0xc2 (ivtv i2c driver #0)
tda9887 0-0043: chip found @ 0x86 (ivtv i2c driver #0)
cx25840 0-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #0)
ts: Compaq touchscreen protocol output
cx25840 0-0044: unable to open firmware v4l-cx25840.fw
wm8775 0-001b: chip found @ 0x36 (ivtv i2c driver #0)
ieee1394: Host added: ID:BUS[0-00:1023]  GUID[0011d8000146fe1e]
ivtv0: unable to open firmware v4l-cx2341x-enc.fw
ivtv0: did you put the firmware in the hotplug firmware directory?
ivtv0 warning: failed loading encoder firmware
ivtv0 warning: Error loading firmware -3!
ivtv0: Error -3 initializing firmware.
ivtv0: Error -12 on initialization
ivtv: probe of 0000:05:01.0 failed with error -12
ivtv:  ====================  END INIT IVTV  ====================

Installer les packages ivtv par le MCC. dmesg doit donner cela:

ivtv:  ==================== START INIT IVTV ====================
ivtv:  version 0.7.3 (tagged release) loading
ivtv:  Linux version: 2.6.17-13mdv SMP mod_unload 686 gcc-4.1
ivtv:  In case of problems please include the debug info between
ivtv:  the START INIT IVTV and END INIT IVTV lines, along with
ivtv:  any module options, when mailing the ivtv-users mailinglist.
usb 6-1: new low speed USB device using uhci_hcd and address 3
usb 6-1: configuration #1 chosen from 1 choice
input: Microsoft Microsoft 3-Button Mouse with IntelliEye(TM) as /class/input/input1
input: USB HID v1.10 Mouse [Microsoft Microsoft 3-Button Mouse with IntelliEye(TM)] on usb-0000:00:1d.2-1
usbcore: registered new driver usbmouse
drivers/usb/input/usbmouse.c: v1.6:USB HID Boot Protocol mouse driver
ivtv0: Autodetected Hauppauge WinTV PVR-150 card (cx23416 based)
ACPI: PCI Interrupt 0000:05:01.0[A] -> GSI 17 (level, low) -> IRQ 17
tveeprom 0-0050: The eeprom says no radio is present, but the tuner type
tveeprom 0-0050: indicates otherwise. I will assume that radio is present.
tveeprom 0-0050: Hauppauge model 26159, rev G1A5, serial# 10387336
tveeprom 0-0050: tuner model is TCL MPE05-2 (idx 105, type 38)
tveeprom 0-0050: TV standards PAL(B/G) PAL(I) SECAM(L/L') PAL(D/D1/K) (eeprom 0x74)
tveeprom 0-0050: audio processor is CX25843 (idx 37)
tveeprom 0-0050: decoder processor is CX25843 (idx 30)
tveeprom 0-0050: has radio, has IR remote
tuner 0-0061: chip found @ 0xc2 (ivtv i2c driver #0)
tda9887 0-0043: chip found @ 0x86 (ivtv i2c driver #0)
cx25840 0-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #0)
cx25840 0-0044: loaded v4l-cx25840.fw firmware (16382 bytes)
ts: Compaq touchscreen protocol output
  Vendor: Generic   Model: USB SD Reader     Rev: 1.00
  Type:   Direct-Access                      ANSI SCSI revision: 00
wm8775 0-001b: chip found @ 0x36 (ivtv i2c driver #0)
sd 7:0:0:0: Attached scsi removable disk sdc
  Vendor: Generic   Model: USB CF Reader     Rev: 1.01
  Type:   Direct-Access                      ANSI SCSI revision: 00
sd 7:0:0:1: Attached scsi removable disk sdd
  Vendor: Generic   Model: USB SM Reader     Rev: 1.02
  Type:   Direct-Access                      ANSI SCSI revision: 00
sd 7:0:0:2: Attached scsi removable disk sde
  Vendor: Generic   Model: USB MS Reader     Rev: 1.03
  Type:   Direct-Access                      ANSI SCSI revision: 00
sd 7:0:0:3: Attached scsi removable disk sdf
usb-storage: device scan complete
sr 1:0:0:0: Attached scsi generic sg0 type 5
sd 2:0:0:0: Attached scsi generic sg1 type 0
sd 3:0:0:0: Attached scsi generic sg2 type 0
sd 7:0:0:0: Attached scsi generic sg3 type 0
sd 7:0:0:1: Attached scsi generic sg4 type 0
sd 7:0:0:2: Attached scsi generic sg5 type 0
sd 7:0:0:3: Attached scsi generic sg6 type 0
ieee1394: Host added: ID:BUS[0-00:1023]  GUID[0011d8000146fe1e]
ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
ivtv0: Encoder revision: 0x02050032
ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total)
ivtv0: Allocate DMA encoder YUV stream: 161 x 12960 buffers (2048KB total)
ivtv0: Allocate DMA encoder VBI stream: 80 x 26208 buffers (2048KB total)
ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total)
ivtv0: Create encoder radio stream
tuner 0-0061: type set to 38 (Philips PAL/SECAM multi (FM1216ME MK3))
ivtv0: Initialized Hauppauge WinTV PVR-150, card #0
ivtv:  ====================  END INIT IVTV  ====================

[modifier] Récupération des vidéos et visualisation

[utilisateur@ordi ~]$ cat /dev/video0 > video.mpg

[modifier] Liens

• http://forum.mandriva.com/viewtopic.php?t=67869&highlight=wintv